Elite Cement - Product Data - Repair Mortar 30

PRODUCT DATA SHEET

REPAIR MORTAR 30

Patching Mortar for use on AAC Panels

REPAIR MORTAR 30 is a crack resistant, non shrinking, patching mortar for use on autoclaved aerated concrete panels. REPAIR MORTAR 30 sets in 15 - 30 minutes to form a permanent bond to existing surfaces. REPAIR MORTAR 30 is both color and texture matched to autoclaved aerated concrete so that repairs to surface damages blend in with the surrounding substrate.

REPAIR MORTAR 10 is also available in a formulation designed to set in only 5 - 10 minutes.

Surface
Preparation All bases to receive REPAIR MORTAR 30 must be clean and free of grease, oil, dirt, paint, and other foreign residues. The surfaces must always be wetted before application of mortar.

Mixing One bag of REPAIR MORTAR 30 is mechanically mixed with 4 gallons of water. Do not re-temper mortar.

Application Fill patches with mortar to extend over the edges of the damaged area. After initial setting, level surface flush with the plane of substrate using a rasp or angle plane. After the patch hardens, decorative coatings may be applied.

Precautions Do not apply if temperature is expected to drop below 40⁰F within 24 hours of application.

Drying Time Depending on temperature and humidity, mortar cures in 2 to 5 days.

Cleaning Immediately after use, rinse with water.

Coloring Approximates autoclaved aerated concrete color.

Package Size 55 pound bag

Coverage One cubic foot per bag.

Storage Product storage is one year from manufacture. Protect from moisture.
Technical Data

Wet Density
Water Vapor Permeance
Compressive Strength
Modulus of Elasticity 82 lbs./ft.³
50 lbs./ft.³
600 psi
285,000 psi

Short Form Specifications for REPAIR MORTAR 30

Surface Preparation	All bases to receive REPAIR MORTAR 30 must be clean and free of grease, oil, dirt, paint, and other foreign residues. The surfaces must always be wetted before application of mortar.
Mixing	One bag of REPAIR MORTAR 30 is mechanically mixed with 4 gallons of water. Do not re-temper mortar.
Application	Fill patches with mortar to extend over the edges of the damaged area. After initial setting, level surface flush with the plane of substrate using a rasp or angle plane. After the patch hardens, decorative coatings may be applied.
Precautions	Do not apply if temperature is expected to drop below 40⁰F within 24 hours of application.
Drying Time	Depending on temperature and humidity, mortar cures in 2 to 5 days.
Cleaning	Immediately after use, rinse with water.
Coloring	Approximates autoclaved aerated concrete color.
Package Size	55 pound bag
Coverage	One cubic foot per bag.
Storage	Product storage is one year from manufacture. Protect from moisture.