GROUTFLO ADDITIVE is a high range plasticizer which increases the flow ability and placement of sand/cement grouts. When added to sand/cement mixes GROUTFLO ADDITIVE converts difficult to place grouts into pourable mixture without lowering the strength or increasing the shrinkage. GROUTFLO ADDITIVE is ideal for use in grouts used to fill the keys between autoclaved aerated concrete floor panels and for U-block grouting.

Specify for grouting autoclaved aerated concrete floor panels for exterior or interior surfaces.

Specify for grouting masonry or AAC U-Block for exterior and interior applications.

Specify for above or below grade application.

PART 1 GENERAL

Submittals

Product Data: Submit manufacturers technical information and installation
    instructions for materials required.

Samples: Submit for review, sample of texture. Submit for review,
    sample of color (color chart).

Quality Assurance

Provide all coatings, adhesives, and sealants from one source.

Provide job site mock-up sample (2 ft. X 2 ft.) showing texture and color.

Sample to be accepted by architect/engineer prior to starting work.

Remove sample when directed by architect/engineer.

Delivery, Storage and Handling

Deliver and store packaged material in original containers, unopened.
    Prevent damage to materials from water, freezing, or other causes.

Provide heated and dry storage conditions for materials at site.

Remove unused materials and waste from project site.

Project Conditions

Maintain environmental conditions and protect work during and after
    installation and comply with manufacturer's printed instructions.

Maintain temperatures at not less than 40⁰ F for a minimum of 48 hours after installation.

Do not apply to frozen surfaces or surfaces containing frost.

Do not apply when ambient temperature is above 110⁰ F.


For performance specifications please call Elite Cement Products, Inc. for product characteristics.


PART 2 PRODUCTS

Materials

When specifying GROUTFLO ADDITIVE, refer to
    manufacturers recommendations prior to application.



Mixes

Mix coating according to manufacturer's written instructions.

PART 3 EXECUTION

Inspection

Verify substrate surface is ready to receive installation of work.

Verify that surfaces are free of dust, loose particles, oil, or other
    foreign materials.

Do not proceed with work until surfaces and conditions comply
    with manufacturer's requirements.

Preparation

Prepare substrate in accordance with manufacturer's instructions.

Installation

Install coating in accordance with manufacturer's printed instructions.

No American standards for coatings on autoclaved aerated concrete
    exist at this time.

Protection

Protect surface from damage or contamination from foreign materials.

Maintain protection until completion of work.

Cleaning

Remove product and protective materials from job site.

GROUTFLO Product Data Sheet



For further information contact
Elite Cement Products, Inc.
P.O. Box 48823
Atlanta, GA 30362
(770) 448-0856